Home › Forums › Hardware › Can we get the execution time from the AUDESSE?

Tagged: 

Viewing 1 reply thread
  • Author
    Posts
    • yahuizhaoyahuizhao
      Participant
      June 14, 2024 at 2:43 am
      Post count: 1
      #17736

      Hi!Our ultimate goal is to get the execution time from the AUDESSE as attached picture. To be specific, we hope to get an observable variable that shows that our computation time is smaller than the fixed step length. If we can get it, please write the specific operation steps as detailed as the you could. If not, please tell us too. Thanks for your time and I look forward to hearing from you.Thanks!

      Attachments:
      You must be logged in to view attached files.
    • AmirFAmirF
      Moderator
      June 14, 2024 at 12:19 pm
      Post count: 17
      #17747

      Dear Yahuizhao,

      I assume you are asking this question for an FCS device and you are running your algorithm on the main MCU on board. To find out the exact runtime of an algorithm running on the main MCU on Simulink, you can put the algorithm in an atomic subsystem and use the profiler block.
      Please take a look at the following link as well. There is a similar question asked.
      https://community.nxp.com/t5/Model-Based-Design-Toolbox-MBDT/LPTMR-Get-Counter-Value/m-p/1828783#M8918

      Sincerely,
      Amir

  • Author
    Posts
Viewing 1 reply thread
  • You must be logged in to reply to this topic.