Forum Replies Created

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • kanteshbondlakanteshbondla
    Participant
    Post count: 13

    Hello Amir,

    We have tested all the DIs on the TC64 with red beet, but only DI 12 is not working even with right configurations.

    kanteshbondlakanteshbondla
    Participant
    Post count: 13

    Hi Amir,

    We’re working on integrating the DC charging software into the VCU. The code is quite extensive, with numerous variables, structures, and sequences to manage for the DC charging process. Currently, we’re using the free master tool for testing, but it isn’t meeting our needs. We require step-by-step testing in the S32 Design Studio, which necessitates flashing over JTAG

    • This reply was modified 2 months, 2 weeks ago by kanteshbondlakanteshbondla.
    kanteshbondlakanteshbondla
    Participant
    Post count: 13

    Hello Sandeep,

    I am Facing a problem with freemaster over Peak CAN, I have done the configuration for CAN1 & CAN2. On default hardware settings from nxp for CAN0 & CAN4, I am able use freemaster over peak CAN over CAN0 but not for CAN2. There are some pins configured in default config like CAN0_EN, CAN0_STB & CAN0_ERRN are configured, As per this i serached for more & than got to know that these pins enable CAN transreciever, So i need to Know the same about pins for CAN1 & CAN2. which pins enable CAN1 & CAN2 transreceiver. Because not enabling these pins would not let me use CAN2 for freemaster. I have attached a png for your reference. Provide a Document or schematic for flex Case E.

    Attachments:
    You must be logged in to view attached files.
    kanteshbondlakanteshbondla
    Participant
    Post count: 13

    Hello Sandeep,
    Thanks for the support, Its working as expected now. We can close this topic.

    kanteshbondlakanteshbondla
    Participant
    Post count: 13

    Hello Sandeep,
    Thanks for the prompt reply.

    1) For Setting “EN_Can4” as high, we are using PTG16 pin
    2) For Toggling “CAN4_STB” to high then low, we are using PTG19
    3) Which pin should we use to toggle “EN_Lin” as high then low ?

    kanteshbondlakanteshbondla
    Participant
    Post count: 13

    Hello Connor,
    1) We are using the Matlab/Simulink for the algorithm
    2) We are capturing CAN messages on polling
    3) I have tested the CAN messages by shuffling the buffers, but in each case the FlexCase E is dropping CAN frames only for BMS messages, but we can see every message from BMS on Peak CAN adapter without any drops.

    kanteshbondlakanteshbondla
    Participant
    Post count: 13

    I am using MATLAB/Simulink for developing my application software. The main objective of our software is to store data in EEPROM for example Odometer data in Vehicles. But we realized that S32K344 does not have an Internal EEPROM, so we are planning to use a part of flash as emulated EEPROM by using FLS and FEE driver.
    Please help us to configure these drivers or suggest us any better method to store data in EEPROM.

Viewing 7 posts - 1 through 7 (of 7 total)