[sandeepjayabal]

in reply to: Missing information on MPU Digital Inputs #18464

Hi Craigbeal,

In addition to the information above:

Please find the link to the datasheet https://www.audesseinc.com/resources/datasheet/?model_sku=FlexBench+1.2&fusion-form-nonce-17520=f102ce5f7b

In the datasheet, when the mouse pointer is hovered over each pin, the GPIO name (shown in red) pops up and its corresponding connector pins (shown in yellow box), Breakout board (shown in green box) is listed.

Please let me know if this clarifies your query or incase otherwise please let me know.

Thanks
Sandeep Jayabal

• This reply was modified 4 months ago by sandeepjayabal.

Attachments:

You must be logged in to view attached files.

[sandeepjayabal]

in reply to: Missing information on MPU Digital Inputs #18462

Hi craigbeal,

Please find the information below:

The Digital inputs can be configured for Pull up / pull down based on requirements using the (hardware) DIP switch. It is not software configurable for FCB 1.2.

Toggle the “MPU DI-10K-PD” for pull down configuration and “MPU DI-10K-PU” for pull up configuration. (shown in the image)

Kindly refer to the digital input guide https://www.audesseinc.com/resources/digital-input-guide/ for additional details

Please do let me know for any further support

Thanks
Sandeep Jayabal

Attachments:

You must be logged in to view attached files.

[sandeepjayabal]

in reply to: Missing information on MPU Digital Inputs #18458

Hi craigbeal,

Please find the information that you were looking for in our webpage.

Link: https://www.audesseinc.com/resources/digital-input-guide/

Let us know for any further questions

Thanks
Sandeep Jayabal

[sandeepjayabal]

in reply to: Missing information on MPU Digital Inputs #18393

Hi craigbeal,

Thanks for raising this concern,

We are currently working on this information and we will get back to you with the Digital Inputs webpage for your convenience at the earliest.

Thanks
Sandeep Jayabal

[sandeepjayabal]

in reply to: How to Disable Wake on CAN for Flex Case E ? #18297

Hello Kantesh,

Please use the PTB19 for the EN_Lin.

Thanks
Sandeep

[sandeepjayabal]

in reply to: How to Disable Wake on CAN for Flex Case E ? #18234

Hello Kantesh,

Please find the attached steps below:

1. Set “EN_Can4” high
2. Toggle “CAN4_STB” to high then low.
3. toggle EN_Lin high then low.

Give every step at least 100 ms.

This step will disable CAN Wake. Let me know for any further queries.

Thanks
Sandeep

[sandeepjayabal]

in reply to: How to Disable Wake on CAN for Flex Case E ? #18064

Hi,

Thanks for reaching out to us.

We will test the steps and get back to you with a solution as soon as possible.

[Author]

Posts